CARLO GAVAZZI

Energy Management

Transducers, Energy Meters, Power Analyzers, Current and Voltage Transformers, Serial Communication modules.

Compact Transducers for AC, DC and frequency measurement. Power Transducers, power analyzers and energy meters for network management of electrical lines in industrial and residential applications. DIN-rail or panel mounting types.

Sense Switch Control Safety
Temperature Sensors Solid State Relay Energy Management Safety Module
Proximity Sensors Motor Controller Temp. Controller / Scanner Safety light Curtain
Ultrasonic Sensors Power Supply Timer / Monitoring Relay Safety Switches
Level Sensors PCB Relay Counter Thyristor fuses
Humidity Sensors Converters Heater Control Safety Magnetic Switches

Monitoring Solutions for Water and Pumps Applications

Your issue: What happens if my pump runs dry? What if the phases sequence is not correct or one phase fails.

Monitoring Solutions for Energy Generation Applications

Your issue: With an increased use of generators in a lot of application it's absolutely necessary that the mains out of the generator is of high quality to avoid damages to the load connected.

Monitoring Solutions Applications for Material Handling

Your issue: All the industrial applications where sophisticated mechanical machines are used to manufacture, pack-age, mix... they need a high quality mains. A faulty system can cause poor product quality.

Packaging

Your issue: Industrial plants using advanced technological machines to optimize the productivity level and the product quality often need to monitor the quality of the mains.

Monitoring Solutions Applications for Lift

Your issue: For Lifts the direction of the motion must be 100% correct. Phase sequence relays are a fast, reliable and easy to maintain solution. In case of overload the motor temperature can damage and eventually break the motor itself.

HVAC

Your issue: Correct direction means higher efficeincy of the compressor (in some cases incorrect rotation means immediate break down).You never know what's going to happen after the compressor has been set up. Furthermore, starting more than one compressor of the same time can cause a high inrush current with several problems like EMC noise or low mains voltage.

  • 15 Amp models
  • Economical open board design
  • ideal for high volume applications
  • Settings for ramps and initial torque
  • 3,12 & 25Amp models
  • Soft starting & stopping
  • Single Ø available
  • Transient over voltage protection built-in
  • 25, 36 & 45 amp models
  • Soft starting & supporting
  • Vibration-free starting
  • Integrated heat sink
  • Motor PTC input connection
  • Over- temperature protection
  • 72, 90 Amp models
  • Soft start/stop of all type of three Ø induction motors
  • 10 per-programmed start/stop profiles
  • Phase loss protection at starting
  • Fault status indication